The following information is only for reference. Set the time zone based on the site requirements. This.The time zone varies depending on the location of a switch.
Serial Terminal Emulator Mac OS XIt supports SSL, ANSI and XTERM protocols. Jagacy VT100/VT220 emulator is an easy to use VT100/VT220 terminal emulator written entirely in Java. Jagacy VT100/VT220 Emulator for Linux v.2.1. Runs on: Mac OS X 10.4 or later.![]() ![]() Sysname Switch //Set the switch name to Switch. ANSI/VT100 terminal emulator for the Windows operating system that supports serial port. Re: Wyse Terminal with VT52/VT100/VT300 Emulation, Rick Stevens. Also available for Classic Mac OS as a remote-only shell named. MacTerm v.1.0 MacTerm is a complete terminal emulator for Mac OS X, for use with local or remote applications. User-interface console 0 authentication-mode aaa //Set the authentication mode of the user to AAA. The method of changing the authentication mode is similar and is not provided here.)# Set the authentication mode of the console interface to AAA, and create a local user. In V200R020 and later versions, the default authentication mode for the console user interface is password authentication. (From V200R010 to V200R019, the default authentication mode for the console user interface is AAA authentication. Interface gigabitethernet 0/0/10 //GE0/0/10 is the physical interface used for logging in to the switch through the web system on a PC. Vlan 10 interface vlanif 10 //Configure VLANIF 10 as the management interface. Configure the management IP address and Telnet.# Configure the management IP address. Local-user admin1234 service-type terminal //Set the access type to terminal, that is, console user. Older versions of skype for mac os xUser privilege level 15 //Set the level of users in VTY 0 to VTY 4 to 15. Protocol inbound telnet //Set the protocol supported by the VTY user interface to Telnet. User-interface vty 0 4 //Enter the user interface views of VTY 0 to VTY 4. Telnet server enable //Enable Telnet. Port default vlan 10 //Add GE0/0/10 to VLAN 10.# Configure the Telnet function. Port link-type access //Set the interface type to access. You can also log in to the switch using Telnet. Local-user admin123 password irreversible-cipher //Create a local user named admin1234 and set its password to local-user admin123 privilege level 15 //Set the user level to 15.Warning: This operation may affect online users, are you sure to change the user privilege level ? y local-user admin123 service-type telnet //Set the access type to telnet, that is, Telnet user.When logging in to the switch again through the console port after completing the configuration, you need to enter the user name and authentication password configured in the preceding steps to pass identity authentication and log in to the switch successfully.
0 Comments
Leave a Reply. |
AuthorRobert ArchivesCategories |